Installation EN POWER FOCUS 600
8
© Atlas Copco Industrial Technique AB - 9836 6534 01
Installing the IP54 module
The Power Focus controller is classified as IP54. To achieve the classification IP54 of the Power Focus
controller you need to install the IP54 module.
The IP54 module consists of two parts, one cable plug and one insulation wall. Lubricator for tightening is
also enclosed.
Installing the cable plug
CAUTION
■
Make sure that the mounting surfaces of the cable connector hole and the surfaces on the cable plug
are clean. If there is dust or moisture it may not thighten accurately.
The cable plug is protection fromt dust and other particles, when there is no tool cable attached to the con-
troller.
Make sure that the cable plug is pushed in all the way. The maximum distance, between the bottom sur-
face of the controller and the surface of the cable plug, must be no more than 14mm.
Installing the insulation wall
Required tools
■
Allen key
1. Open the front cover of the controller by pressing the latch on the front. Insert the IP54 insulation wall
by sliding the grooves over the inner walls inside the controller.
2. Remove the screw and the wall cover. Remove one or several of the blue insets, depending on the
number of cables used in the controller.
3. To insert a cable, remove the black core of one of the conduit entries. The insets can be used for ca-
bles with a diameter of 3.5 - 10.5 mm. For cables with a diameter larger than 3.5 mm remove rubber
layers until the cable fits tightly.
Apply the enclosed lubricator on all the blue surfaces to make sure the insulation is tightened
sufficiently.
Put the blue insets back into the insulation wall and connect the cables.
4. Put the wall cover back into position. Make sure that the blue insets are positioned inside the corre-
sponding grooves of the wall cover. Tighten the screw with an Allen key. Close the front cover of the
controller.
To Next Page
Loading...
