To Next Page

To Previous Page

OPERATOR’S AND SAFETY MANUAL

1NO0039UK-00

Zebra 12

 Inspection and controls before start-up.

 Risks related to using the machine near overhead obstacles, other moving machines,

holes, obstacles on the ground and tilt.

 Risks related to using the machine near conductors or powered electrical equipment.

 Use of an approved fall-protection mechanism.

 Safety requirements related to a task or specific use of the machine.

2.1.2 INSPECTION OF THE WORKPLACE

 Before using the machine, the operator must take precautions to avoid any risk in the

workplace:

- Note the hazardous locations in the working area.

- Note the overhead obstacles, the electrical lines, overheadcranes, cranes or other

elements.

- Note on the ground the presence of holes, bumps, tilt, debris and coatings likely to hide

holes or other dangers.

- Check that the ground is able to support the wheel load.

 The machine must only be used in well-ventilated premises.

 The machine must be used with sufficient ambient lighting.

 The platform must not be raised if the machine is on the platform or trailer of a truck, on a

train, a ship or any other mobile or non-stabilised structure.

 Do not operate the machine in hazardous environments unless approved for that purpose

by ATN.

 DO NOT use the machine in presence of electromagnetic fields (radar, high voltage

currents…). This could damage the machine’s electronic components

2.2. TIPPING RISKS

 Never exceed the working platform's load capacity. Distribute the load evenly across the

platform floor.

 Hold down all the loads inside the working platform. Do not suspend a load from any part of

the platform or lifting structure. Do not place a load on the guard rail.

 Check that the ground is able to support the maximum wheel load.

 Do not drive the machine on slopes or tilts that exceed the maximum acceptable incline.

 Do not raise the platform or move with the platform on inclines, hilly or loose surfaces.

Always make sure that the machine is on a firm and even surface before raising the working

platform or moving with the platform raised.

 Keep the machine a good distance from holes, bumps, tilt, debris and coatings likely to hide

holes or other dangers on the ground.

 Do not raise the working platform if the wind speed is greater than 12.5m/s (45km/h).

ATN Zebra 12 Operator's And Safety Manual

Other manuals for ATN Zebra 12