Atrust t170 - LED Indicators; Before Getting Started; Descriptions of Signals for LED Indicators; About FBWF (File-Based Write Filter)

Overview
LED Indicators
7
1.6 LED Indicators
Your t170 is equipped with a Power LED to indicate the state of power. The meanings of LED signals
are described as follows:
LED Signal Meaning
Power LED
Off The client is off.
Orange The client is in Sleep mode.
Blue The client is on.
The LAN port of your t170 has two LED indicators showing the state of networking. The meanings of
LED signals are described as follows:
Left LED
(transmission rate)
Right LED
(transmission activity)
Meaning
LED Signal
Off Off The client is not connected to a LAN.
Off Amber blinking The client connects to a 10 Mbps LAN.
Orange Amber blinking The client connects to a 100 Mbps LAN.
Green Amber blinking The client connects to a 1000 Mbps LAN.
1.7 Before Getting Started
About FBWF (File-Based Write Filter)
Before getting started on client conguration through the Atrust Client Setup console or through the Windows
Embedded Standard operating system, please note that in a session any changes to the system will not be kept by
default after the system restart. This is due to a special feature called FBWF (File-Based Write Filter) in your Windows
Embedded-based system.
You can change the default via the Atrust Client Setup console. It’s strongly recommended that you read the related
section in this user’s manual rst before making any changes to your system.
WARNING
• Please read the following section FIRST before making any changes to your system:
“4.2.8 Conguring FBWF (File-Based Write Filter)” on page 42.
About Default User Accounts
There are two default user accounts for your Windows Embedded-based system: one is the standard, the other
administrative. The default credentials are shown as follows:
Type Account Name Password
Administrator Administrator Atrustadmin
Standard user User Atrustuser
NOTE
• The passwords are case sensitive.