Atrust t170 - Disabling or Enabling Attached Audio Devices

Conguring Client Settings
Conguring External Device Settings
46
4.3.4 Disabling or Enabling Attached Audio Devices
To disable/enable attached audio devices, please do the following:
NOTE
• If you disable locally attached audio devices, client users are not allowed to perform
audio playback or recording with these devices in an RDP / ICA / View session.
• To perform audio playback or recording with local audio devices in an RDP / ICA /
View session, you need to enable locally attached audio devices here (the Audio
setting item under Devices tab) and congure audio related settings (if any) in the
RDP / ICA / View connection settings. For detailed instructions, please
refer to sections:
 “4.5.5 Conguring Advanced RDP Connection Settings” on page 52
 “4.5.8 Conguring Advanced ICA Connection Settings” on page 70
 “4.5.11 Conguring Advanced View Connection Settings” on page 85
1. On Atrust Client Setup, click Devices > Audio.
2. Click to check/uncheck Enable System Audio Device.
3. Click Save to conrm your selection.
NOTE
• The change will not take eect until the client has been restarted.