AuCom EMXAe - Page 66

PROGRAMMABLE PARAMETERS
6G – Input A Trip
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset Log Only
Trip Starter Trip + Shunt Relay
Trip and Reset
Description:
Selects the soft starter's response to the protection event.
6H – Input B Trip
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter Trip + Shunt Relay
Trip and Reset
Description:
Selects the soft starter's response to the protection event.
6I – Network Communications
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset Log Only
Trip Starter
Stop
Trip and Reset
Trip + Shunt Relay
Description:
Selects the soft starter's response to the protection event. If set
to Stop, the EMX4e will perform a soft stop, then can be
restarted without a reset.
6J – Remote Keypad Fault
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter Trip + Shunt Relay
Trip and Reset
Description:
Selects the soft starter's response to the protection event.
6K – Frequency
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter
Trip + Shunt Relay
Trip and Reset
Description:
Selects the soft starter's response to the protection event.
6L – Phase Sequence
Options:
Soft Trip and Log (default)
Warn and Log
Soft Trip and Reset
Log Only
Trip Starter Trip + Shunt Relay
Trip and Reset
Description:
Selects the soft starter's response to the protection event.
64 | EMX4e User Manual (710-18433-00C)