AuCom MVE series - Standard Menu

CONTROLLER
42 | MVE User Manual (710-17074-00G)
7.13 Standard Menu
The standard menu provides access to commonly used parameters, allowing the user to configure the MVE as required for the
application. For details of individual parameters, refer to
Parameter Descriptions on page 46.
1
Motor Data-1
1A Motor Full Load Current
2
Start/Stop Modes-1
2A Start Mode
2B Start Ramp Time
2C Initial Current
2D Current Limit
2H Stop Mode
2I Stop Time
3
Auto-Start/Stop
3C Auto-Stop Type
3D Auto-Stop Time
4
Protection
4A
Excess Start Time
4C
Undercurrent
4D
Undercurrent Delay
4E
Instantaneous Overcurrent
4F
Instantaneous Overcurrent Delay
4G
Phase Sequence
6
Inputs
6A
Input A Function
6B
Input A Name
6C
Input A Trip
6D
Input A Trip Delay
6E
Input A Initial Delay
6F
Input B Function
6G
Input B Name
6H
Input B Trip
6I Input B Trip Delay
6J Input B Initial Delay
7
Outputs
7A Relay A Function
7B Relay A On Delay
7C Relay A Off Delay
7D Relay B Function
7E Relay B On Delay
7F Relay B Off Delay
7G Relay C Function
7H Relay C On Delay
7I Relay C Off Delay
7M Low Current Flag
7N High Current Flag
7O Motor Temperature Flag