AuCom MVE series - Extended Menu

CONTROLLER
MVE User Manual (710-17074-00G) | 43
8
Display
8A Language
8B F1 Button Action
8C F2 Button Action
8D Display A or kW
8E User Screen - Top Left
8F User Screen - Top Right
8G User Screen - Bottom Left
8H User Screen - Bottom Right
7.14 Extended Menu
The extended menu gives access to all of the MVE's programmable parameters.
1
Motor Data-1
1A Motor Full Load Current
1B Locked Rotor Time
1C Locked Rotor Current
1D Motor Service Factor
2
Start/Stop Modes-1
2A
Start Mode
2B
Start Ramp Time
2C
Initial Current
2D
Current Limit
2E
Reserved
2F
Kickstart Time
2G
Kickstart Level
2H
Stop Mode
2I
Stop Time
3
Auto-Start/Stop
3A
Reserved
3B
Reserved
3C
Auto-Stop Type
3D
Auto-Stop Time
4
Protection
4A
Excess Start Time
4B
Excess Start Time-2
4C
Undercurrent
4D Undercurrent Delay
4E Instantaneous Overcurrent
4F Instantaneous Overcurrent Delay
4G Phase Sequence
4H Current Imbalance
4I Current Imbalance Delay
4J Frequency Check
4K Frequency Variation
4L Frequency Delay
4M Restart Delay
4N Motor Temperature Check
4O Ground Fault Level