Audi A3 1997 - Page 49

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Adaption channel 30 - Correction of fuel gauge sender resistance range
This function can be used to shift the fuel gauge sender resistance range if dash panel insert display does not
correspond to actual tank content.
-> Display on VAS 5051:
1 - Enter channel number
- Use keypad -2- to enter "30" for "Adaption channel 30" and confirm by touching Q key.
-> Display on VAS 5051:
1 - Channel 30
Read and test
2 - Fuel-gauge sender
4 - Moving bar positioned on current adaption value 128
Notes:
◆ The adaption value 128 represents the factory-set mean fuel gauge sender resistance range.
◆ The fuel gauge sender resistance can be changed by ±8 ohms to an adaption value of 120 ... 136.
◆ Dash panel insert replacement => Page 44 .
- Use moving bar to change adaption value =>"A - Changing adaption value with moving bar", Page 22 .
Or
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 24 .
- Enter 5-digit adaption value. Use "0" to fill up empty spaces.
Example:
Desired input: 132
Keypad entry: 00132
Note:
Fault message "Function unknown or cannot be implemented at present" appears if an implausible value is
entered.
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
2.11 - Adaption 43