u.
00
.-<
N
l'-
N
.-<
0
N
>
00
A./ appears in the box. This activation is sepa-
rate from the Infotainment system settings in
the climate control menu
¢ page 116.
~
Press the I BACKI button.
~
To activate the desired timer, confirm the set-
ting with the control knob. A,/ appears in the
box.
Power save mode
Power save mode is automatically switched on
when the control unit has not been operated for
more than one minute. The LEO@ ¢
page 109,
fig. 115 stays on. All other displays turn off.
~
To switch power save mode on or off, press the
~
button @ ¢ page 109, fig. 115.
Power save mode ends automatically when the
vehicle charging connector is plugged into the ve-
hicle.
The high-voltage battery is charging when the
LED@ blinks.
(D Tips
- Auxiliary climate control is powered electri-
cally if you select climate control using the
charging timer. This may also be used in
confined spaces such as garages.
- Using the auxiliary air conditioning while
charging can also reduce the charge level of
the high-voltage battery.
- The high-voltage battery also charges in
power save mode.
- If the charging process is in progress, it will
not be interrupted when power save mode
switches on.
- The charging process can be interrupted at
any time. Press the active button on the ve-
hicle to do this
¢page 109, fig. 116.
- The climate control output while charging
depends on the capacity of the electrical
connection. Additional information on cli-
mate control can be found under
¢ page 116.
e-tron
Setting the charging power level
Appli es to : vehicles w it h pl ug-in hybr id drive
The control unit automatically recognizes the
voltage and the available current strength. You
can set whether you would like to charge with the
full or half of the charging power.
~
Press the I OKI@ ¢ page 109, fig. 115 button
on the control unit.
~
Enter the PIN if necessary.
~
POWER and SET PIN appear in the display
field.
~
Select POWER with the arrow button @ .
~
Press the I OKI button @ .
~
The charging power display appears. The cur-
rent set value (50% or 100%) is marked with a
frame.
~
If necessary, change the setting using the ar-
row button © to move downward or upward.
~
Press the I OKI button @ .
(D Tips
- If a household socket is used for the charg-
ing process, the charging power level is au-
tomatically set to 100%. If multiple electri-
cal consumers are connected to a circuit
'
the charging power may be limited to 50%
when charging with a household socket in
order to relieve the load on the electrical in-
stallation.
- If an industrial socket is used for the charg-
ing process, the charging power level is au-
tomatically set to 50%. To receive the maxi-
mum charging power, the value must be set
to 100% .
- A selected value remains set until the power
cable is connected again.
111
To Next Page
Loading...
