u.
00
.-<
N
l'-
N
.-<
0
N
>
00
e-tron
LED on the control
Symbol
Error code
unit @
Meaning
Solution
Disconnect the control
200,210,
unit from the power sup-
ply and have the malfunc-
260, 410,
Red On Error in the cont rol unit. t ion corrected at an au-
450, 460,
thorized Audi dea ler or au-
490,500
thorized Audi Service Fa-
cility
The control unit is over-
Allow the control unit to
cool down or ope rate it in
180,190 Red On heat ing or not cooled
the specified temperatu re
enough.
range .
Have the malfunction cor-
130, 140,
Red On
Communication to the ve- rected by an authorized
470 hide is malfunctioning. Audi dealer or authorized
Audi Service Facility.
300,310, Error in the househo ld in-
Have the electrical instal-
Red On lation checked by a quali-
370,390
sta llat i on.
fied electrician .
Have the electrica l instal-
480 Red Flashes
Fau lt in the househo ld in-
lation up to the contro l
sta llation. unit checked
by a qualified
electric ian.
Reset the ground fault in-
terrupter with the
IOKI@
Ground fault interrupt er
button
¢page 109,
110 Red Flashes
(GFI) triggered in the con-
fig. 115. Have the electr i-
tro l unit .
cal installation checked by
a qua lified electrician if
the same display appears .
Vehicle: charging unit
LED on the vehicle @ Meaning Solution
High-voltage battery charging
Remove the charger, put the cap
On on and close the cover on the
process is completed .
charg ing unit .
The high-voltage battery is charg-
Pulsating light ing or the vehicle is being air con-
Green ditioned/heated.
Blinks for approx i-
Charging time r was prog rammed
but the charging process has not
mately one minute
started yet. The LED in the button
after leaving the veh i-
CD ¢page 109, fig. 116 also
cle
turns on .
113
To Next Page
Loading...
