Op e ning and clo sing
button II / Program button III (reprogram) .
The yellow LED@ blinks.
~
Follow the instructions in the Infotainment sys -
tem.
Synchronizing a button
1
>
Requirement: the button must already be pro -
grammed and must be synchronized with the
system that you would like to program.
~
Switc h the ign ition on.
~
Press the button in the head liner that you
would like to synchronize.
~
Follow the instructions in the Infotainment sys -
tem.
Deleting button programming
The programmed buttons cannot be de leted ind i-
vidua lly. They must be deleted all at once . Repro-
gram the buttons if necessary .
~
Switc h the ign ition on.
~
Select in the Infota inment system: I MENU I but -
ton
> Vehicle > left contro l button > Vehicle
settings > Garage door opener > Delete button
programming > Yes, delete now.
Displaying the version/s tatu s/ country code
~
Select in the Infota inmen t system: IM ENU I but -
ton
> Vehi cle > left contro l button >Vehicl e set-
tings > Garage door opener > Version inf orma-
ti on.
(D Tips
- The garage door opener may need to be
synchronized with the system motor after
the programming . Follow the manufactur -
er's instructions for doing t his.
- The programming process can take up to 30
seconds . The hand transmitter may need to
be operated again during the process.
- Make sure the batteries in the hand trans -
mitter are charged before starting the pro-
gramming process.
- In some cases, the system must be pro -
grammed using an alternative mode. Select
in the Infota inment system :
IMENU I > Vehi-
1
> Only appl ies to rolling code system s
42
cle > left control button > Vehicle settings >
Garage door opener > Program garage door
opener >
right control button > UR-Mode /
D-Mode .
To Next Page
Loading...
