a
co
....
N
r--.
N
....
0
0
:E
'<I'
Power steering wheel position adjustment
Applies to: vehicles with power steering whee l adjustment
The steering wheel position con be adjusted elec-
trically up and down and forward and bock.
Fig. 80 Steerin g colum n: switch to adjust th e steeri ng
whee l pos ition
.. To adjust the height, press the switch up/down .
The steer ing column will cont inue moving as
long as you are pressing the switch .
.. To move the steering wheel forward or back,
press the switch forward/back. The steering
column will continue moving as long as you are
pressing the switch.
The steering wheel can also be adjusted when the
ignition is switched off .
In vehicles with memory function*, the steer ing
column sett ings are stored together with the
seat position.
Easy seat entry
Applies to: vehicles with powe r steering wheel adjustment
Easy seat entry makes it easier to enter and exit
the vehicle by adjusting the steering column au-
tomatically.
.. Select in the Infotainment system: !MENUI but-
ton
> Vehicle > left contro l button > Vehicle
settings> Seats> Driver's seat> Easy entry
function .
When easy seat entry is switched on, the steering
column goes back up into the park position when
the ignition is switched off. Afte r entering the ve-
hicle, the steering column returns to the stored
position once the ignition is switched on.
Driving
Starting and stopping
the engine
Starting the engine
The !STAR T ENGINE ST OPI button switches the
ignition on and starts the engine.
Fig. 81 Cockpit : START ENGINE STOP butto n
Starting the engine
.. Press the brake pedal.
.. Press the
!START ENGINE STOP ! button
c;, fig. 81 . The engine will start.
Switching the ignition on/off
If you would like to switch the ignition on with-
out starting the engine, follow these steps:
"' Press the
!ST AR T ENGINE ST OP I button with -
out pressing the brake pedal. Vehicles without
the Start/Stop system*: the need le in the tach-
ometer moves into the
READY position .
.. To switch the ignition off, press the button
again. The needle in the tachometer moves into
the
OFF position.
Equipment that uses a lot of electricity is switch-
ed off temporarily when you start the engine.
If the engine does not start immediately, the
starting procedure stops automatica lly after a
short time. Repeat the starting procedure .
Applies to: vehicles with diesel engine: it may
take slightly longer for the engine to start when
temperatures are coo ler. Therefore, you must
continue pressing the clutch pedal (manual
transmission) or the brake pedal (automatic
transmission) until the engine starts. The
IJ in-
dicator light turns on while the engine is preheat-
ing .
IJJI>
77
To Next Page
Loading...
