S e ats and stor a ge
Luggage compartment net
Applies to: vehicles with luggage compartment net
The cargo net prevents small objects from slid-
ing .
Fig. 72 Luggage compartment: cargo net stretched out
.. Attach the hooks for the luggage compartmen t
net in the tie-downs r::!> fig. 72 .
Cargo floor
Fig. 73 Luggage compartme nt: insta lling the cargo floor
Removing and installing the cargo floor
.. To remove the cargo floor, pull the ent ire cargo
floor towa rd the back of the veh icle .
.. To insta ll the cargo floor, insert the tabs at
both sides into the openings and slide the car-
go floor all the way in toward the backrest
<::!>fig. 73.
64
Roof rack
i
ii
..
j
Fig. 74 Roof: mount ing po ints for the roof rack
.. To open the flap above the attachment po ints,
press the flap downward in the front area.
If Luggage or cargo is to be carr ied on the roof,
you must observe the follow ing:
- Only a specially designed roof rack may be used
on your vehicle . These roof racks a re the bas is
for a complete roof rack system . Additional at-
tachme nts/carr ier systems are necessary to
transpo rt luggage and spo rt s equ ipment. We
recommend roof rac ks and at tac hments from
the Audi Genuine Accessories program.
- When installing the roof rack, make su re that it
is mounted only at the des ignated po ints on
the roof
r::!> fig. 74.
- Note t he permitted axle load, permitted total
weigh t , and permitted roof Load of your veh icle
c::> page 3 76. The roof Load is the total of the
weight of the roof rack, the attachments and
the cargo you are carry ing. However, you must
also note the perm itted Load of the carrier sys-
tem being used.
A WARNING
- Follow the installation instructions prov ided
with the roof rack system . If yo u do not se-
cure the roof rack system and objects on the
roof correctly, they could come Loose from
the vehicle and cause a n accident.
- The risk of an accident increases when using
a roof rack system, bec au se it changes the
driving characte ristics by shift ing the center
of grav ity and/or the increasing the surface
area exposed to wind. You may need to
~
To Next Page
Loading...
