46
Menu/Task Bar Icons
MacOS
On MacOS, the iD icon appears in the menu
bar in the top right hand corner of the screen.
This gives you quick access to various functions
of the iD48. Please note that some functions
are only visible when the iD48 is connected to
the Computer.
Show Mixer
Opens the iD Software Mixer Application.
If the mixer is already open, this option
will be greyed out. The Mixer cannot be
opened unless the iD48 is connected to the
Computer.
About iD
Displays information regarding the current
version of the iD Software Mixer Application.
Visit iD Knowledge Base
Opens a browser window for the Audient
Helpdesk with helpful articles and FAQ’s.
Register Product
Will open the registration screen allowing you
to register your product to Audient ARC if you
have not already done so as part of the initial
setup.
Check for Updates
The iD application will check with the Audient
update server for any available firmware
updates for iD48.
Set Clock Source
Allows you to quickly adjust the clock source
between the internal and optical clocks.
Set Loopback Source
Here you can select which Output Channel
or Mix will feed the Loopback inputs.
Store Standalone State
It is possible to save your Software Mixer
setting onto the iD48 itself so that the iD48
can be used as a standalone device without it
being connected to a computer via USB.
To do this, first setup the software mixer as
desired. Now, go to the Menu bar and click
‘Setup > Store Standalone State’. The current
mixer settings will then be stored to the unit.
The next time the unit is powered down and
powered up again, it will default to these
saved settings.
Please note, its only possible to store one
Standalone State at one time and storing a
new state will overwrite the previous one.
To Next Page
Loading...
