Audient iD48 - Logic Pro Setup

51
Operation with Logic Pro
Once iD48 has been successfully installed
following the steps detailed after page 9 of
this manual, launch Logic Pro and check the
following:
Logic Pro > Preferences > Audio
Ensure that iD48 is selected as the active
audio device and set the buer size (to aect
system latency). If you are experiencing issues
with playback stability and CPU loading, try
increasing the buer size. This appears with
‘overload’ errors and/or pops and clicks and
distortion in the audio.
Logic Pro Setup
Logic Pro Setup
If you are using the iD Software Mixer
Application to monitor input signals while
recording, be sure to disable Logic’s software
monitoring to avoid phasing as the same
source will be heard twice with a short delay
between the low latency DSP signal and the
delayed software monitoring signal.
Assigning I/O
All of iD48’s input and output channels will
be available to Logic for routing. There are
a total of 24 inputs and 24 outputs reported
from the driver. You can rename input and
output channels to whatever you wish using
the I/O label function. This is a great way to
keep things organised.
Mix > I/O Labels