Preparation for use
13
Rotating the platter
1
Using your hands, rotate the platter ten times.
Raise the tonearm lift control lever to lift the tonearm. Slowly rotate the turntable ten times by hand in the
direction of the arrow.
You may want to hold the tonearm to prevent it from moving. This step is for getting rid of any twists in the
belt and making sure the belt rides smoothly along the drive rim on the underside of the platter.
Assembling the tonearm
1
Remove the cable tie used to secure the tonearm at the time of delivery.
2
Insert the headshell into the tonearm.
Hold the right and left edges of the headshell so that you do not damage the stylus or cut the cartridge’s
wires.
3
With the headshell inserted, turn the locking ring counterclockwise (to the left).
4
Attach the counterweight to the back of the tonearm and slowly turn it counterclockwise (to the
left).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
