Audio Technica AT-LP3XBT User Manual

42
Troubleshooting
The platter does not spin.
Is the AC adapter connected to the outlet? Connect AC adapter to the outlet.
Has the belt slipped from the platter? Correctly place the belt on the platter.
Is the belt placed on the motor pulley? Check that the belt is placed on the motor pulley (brass-colored)
correctly.
Has the belt been damaged? Replace it with a new belt.
The platter spins, but there is no sound or the volume is not loud enough.
Is the cartridge’s protector still attached to the cartridge? Remove the cartridge’s protector.
Is the tonearm lifted? Lower the tonearm.
Are the function settings and input for connected equipment (amplifier, etc.) selected correctly? Check
whether the settings for the connected equipment are correct.
Is the stylus damaged? Check the stylus and replace it, if necessary.
Is the stylus placed correctly on the body of the cartridge? Check the cartridge and adjust it, if necessary.
Are the setting positions for the pre-amplifier selector switch correct? Check that the pre-amplifier selector
switch is set correctly to match the input on the amplifier.
If there is no sound, or if the volume is not loud enough, the product is set to the “PHONO” position and
connected to the amplifier’s AUX/LINE input.
If the volume is too loud or is distorted, the product is set to the “LINE” position and connected to the
amplifier’s PHONO input.
Is the tracking force set too heavy? Adjust the tracking force.
The stylus skips.
Is the tracking force set too light or too heavy? Adjust the tracking force.
Is the anti-skate set improperly? Verify anti-skate is set for same value as cartridge tracking force.
Is the record warped? Check the record.
Is the record scratched? Check the record.
Is the stylus dirty? Excessive accumulation of dirt and dust on the stylus affects the record’s playback quality.
There is howling.
Is the product picking up excessive vibrations from the floor, surfaces of the walls, or nearby speakers?
Decrease the vibrations or mount the product on a surface that is not subject to the effects of vibrations.

Audio Technica AT-LP3XBT Specifications

General

Type	Belt-drive audio turntable
Operation	Fully automatic
Motor type	DC motor
Product color	White
Wow & flutter	0.2 %
Nominal speeds	33 1/3, 45 RPM
Platter material	Aluminum
Signal-to-Noise Ratio (SNR)	60 dB
Frequency range	2402 - 2480 Hz
Power supply type	AC
AC adapter frequency	50 - 60 Hz
AC adapter input voltage	100 - 240 V
AC adapter output current	0.6 A
Power consumption (typical)	2 W
Quantity	1
Cables included	RCA
Dust cover included	Yes
Bluetooth version	5.2
Bluetooth profiles	A2DP
USB ports quantity	-

Weight and Dimensions

Depth	374 mm
Width	435.6 mm
Height	128 mm
Weight	5000 g