AUMA SAV Series User Manual

305.2.3. Terminal compartment (for mains connection): close
315.2.4. Fieldbus terminal compartment: open
315.2.5. Industrial Ethernet cable: connect
325.2.6. Fieldbus terminal compartment: close
335.3. Accessories for electrical connection
335.3.1. Actuator controls on wall bracket
335.3.2. Parking frame
345.3.3. DS intermediate frame for double sealing
345.3.4. External earth connection
356. Operation................................................................................................................................
356.1. Manual operation
356.1.1. Engage manual operation
356.1.2. Manual operation: disengage
366.2. Motor operation
366.2.1. Local actuator operation
376.2.2. Actuator operation from remote
376.3. Menu navigation via push buttons (for settings and indications)
386.3.1. Menu layout and navigation
396.4. User level, password
396.4.1. Password entry
406.4.2. Password change
406.5. Language in the display
416.5.1. Language change
427. Indications..............................................................................................................................
427.1. Indications during commissioning
427.2. Indications in the display
437.2.1. Feedback indications from actuator and valve
457.2.2. Status indications according to AUMA classification
467.2.3. Status indications according to NAMUR recommendation
487.3. Indication lights of local controls
497.4. Optional indications
497.4.1. Mechanical position indication via indicator mark
497.4.2. Mechanical position indication (self-adjusting)
508. Signals (output signals).........................................................................................................
508.1. Status signals via output contacts (digital outputs)
508.1.1. Assignment of outputs
508.1.2. Coding the outputs
508.2. Analogue signals (analogue outputs)
519. Commissioning (basic settings)...........................................................................................
519.1. Type of seating: set
529.2. Torque switching: set
539.3. Limit switching: set
559.4. Output speed (internal): set
579.5. Fieldbus address (slave address), baud rate, parity and monitoring time: set
579.5.1. Modbus TCP/IP gateway: set
579.6. Test run
579.6.1. Direction of rotation at mechanical position indicator: check
589.6.2. Direction of rotation at hollow shaft/stem: check
599.6.3. Limit switching: check
3
SAV 07.2 – SAV 16.2 / SARV 07.2 – SARV 16.2 Control unit: electronic (MWG)
ACV 01.2 Modbus TCP/IP Table of contents

AUMA SAV Series Specifications

General

Brand	AUMA
Model	SAV Series
Category	Controller
Language	English