Automatic Systems BL40 User Manual

p 50/58
Technical Manual NAM-BL4x-MT-EN-C
The information in this document is the property of Automatic Systems and is confidential. The consignee withholds from using it for anything other than the use of the products or the execution of the
project to which they belong and withholds from communicating it to third parties without prior written agreement from Automatic Systems. Document subject to change without prior notice.
The barrier closes a
long time after the
vehicle has passed
Closing time delay after
passage is too long
Check the values of the time delays (extended menus).
The barrier opens by
itself.
The opening loop
(optional) is too
sensitive.
Adjust the sensitivity and/or frequency of the opening
sensor. Adjusting the sensitivity adjustment to a setting that
is too high or incorrect frequency can lead to untimely
openings.
The access control
system gives untimely
orders.
Inspect it.
The barrier opens
and closes
immediately
afterwards.
The barrier is not stable
and during opening the
signal from the cell
(optional) is no longer
aligned.
Properly secure the barrier to the ground.
The barrier bounces
in upright and in
horizontal position
Too much stress on the
rubber bumpers inside
the barrier.
Adjust the position sensors (Ch. 5.3. ).
The mains power
turns off when the
barrier is switched
on.
The leakage breaker is
not adapted.
Use a
300 mA leakage breaker for up to three barriers and
for cases requiring a 30 mA system, use a SI type
circuit breaker (Super-Immunised) for each barrier.

Automatic Systems BL40 Specifications

General

Brand	Automatic Systems
Model	BL40
Category	Automobile Electronics
Language	English