18
AM800, AM808 & AM888 Dominator Instruction Manual
WARNING! This operator has a grounding type plug and
there are no user serviceable parts inside this operator.
Fig.7.1.1
7.1 How to Use Your Operator
For maximum efficiency of your operator, your garage door must be in good
operating condition.
An annual service of your garage door by door professional is recommended.
REPLACE WITH BATTERY CR2032
Fig.7.1.2
7.1.1 To Operate the opener:
a. Press the programmed transmitter button until your door begins to move
(usually 2 seconds). Make sure you can see the door when you use the
transmitter (Fig 7.1.1).
b. If you are in a vehicle you should aim the transmitter through your
windscreen as shown.
c. Check that the door is fully open or closed before you drive in or away.
d. If you press the transmitter whilst the door is moving the door will stop.
The next press of the transmitter will move the door in the opposite
direction.
7.1.2 Replacing the Battery: 3V Lithium Battery CR2032.
a. To test the battery is working, press and hold a transmitter button. Check
Light Status table to determine if battery needs replacing
Light Status Battery Status
Solid OK
Flashing Requires replacement
No light Requires replacement
b. Remove screw from back of cover.
c. Use screw driver to separate the transmitter casing to expose circuit
board.
d. Use a non-metallic object (e.g. pen) to remove the battery.
(Fig. 7.1.2).
CAUTION: Activate the operator only when the door is in
full view, free of obstructions and with the operator properly
adjusted. No one should enter or leave the garage while
the door is in motion. Do not allow children to play near
the door.
To Next Page
Loading...
