29
Program Reset
The 764 control can be reset to original factory
parameters when viewing the H0 parameter. Press and
hold the SET button for three seconds while H0 is
displayed. Release the button. All settings except for
Time of Day and Day of Week will be reset. The 764
Logix control will now display the valve and system
type. Refer to Level I Programming.
Note: After any control reset (valve type or system
change, etc.) it is necessary to initiate a manual
regeneration and quick cycle through it. This will
ensure the control and cam are synchronized. If not
synchronized
err# will display and the control will
drive cams to the correct position for valve and system
type programmed.
To Next Page
Loading...
Need help?
General
