Avaya 1120E IP - Headset Configuration Options - Device and Type

Configuring the Avaya 1120E IP Deskphone
89
Table 10 on page 89 describes the configuration options on the Headset
screen.
Table 10: Configuration options on the Headset screen (Part 1 of 2)
Option Function
Active Headset Device Select the active headset device;
either USB or Wired.
Note: The headset can be
selected before it is attached
(wired or USB).
Items below the Active Headset
Device field are dimmed, if either
USB headset is not selected or if
the attached headset is not one
of the Human Interface Device
(HID) supported headset types.
Wired Headset Type Select the type of wired headset
you required.
• Headset Type 1 (Generic
narrow band)
• Headset Type 2 (Wideband)
• Headset Type 3 (Wideband)
Enable HID Commands Enable HID Commands only if
USB headset is selected.
The checkbox is used to enable
the HID commands of supported
headsets to allow the
IP Deskphone to run in generic
mode 1 operation, supporting
both USB audio and HID
commands. The configuration is
ignored for non-supported USB
headsets.