Figure 51: Configure switch
Showing Logs
Display log information to provide additional information.
1.
Use the show logging command to display the log.
2. Observe the log output and note any anomalies.
Showing EAP–non-EAP clients on port
Display EAP–non-EAP client information on the port to provide additional information.
1. Use the show mac-address-table command to show the clients on the port.
2. Observe the log output and note any anomalies.
Troubleshooting authentication
112 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
