Showing EAPOL port information
Display EAPOL port information for additional information.
1.
Use the show eapol port <port#> command to display the port information.
2. Observe the log output and note any anomalies.
Making changes
This section provides troubleshooting guidelines for changing the EAP settings. It assists in
the cleanup of old MAC addresses.
1. Use the eapol status autocommand to change to eap-auto.
2. In the Interface Configuration Mode, use the shut/no shut commands.
EAP–non-EAP unexpected port shutdown
Troubleshooting 5.1 February 2013 113
To Next Page
Loading...
