Customizable system parameters for SIP-based 9600 Series IP Deskphones
Issue 3 January 2014 87
ICMPDU 1 Controls whether ICMP Destination Unreachable
messages will be processed. Values are:
0=DU messages not transmitted
1= DU messages not transmitted in response to
specific events
2= DU message with code 2 will be transmitted in
case of specific events
ICMPRED 0 Controls whether ICMP Redirect messages will be
processed. The valid values are:
● 0: Redirect messages will neither be
transmitted nor processed when received.
● 1: Redirect messages will not be transmitted,
but received Redirect messages will be
supported according to RFC 1122.
INGRESS_DTMF_VOL_
LEVEL
-12 RFC 2833 Digit event "volume" level. The power
level of the tone, expressed in dBm0 after dropping
the sign. (from RFC 2833 section 3.5 "Payload
Format." Values are: -20 to -7.
INSTANT_MSG_ENABLED 1 Enables or disables the Instant Messaging feature.
Values are: 0= Disable, 1 = Enable.
INTER_DIGIT_TIMEOUT 5 This is the timeout that takes place when user
stops inputting digits. The timeout is treated as digit
collection completion, and when it occurs, the
application sends out an invite. Range in seconds
of 1 to 10.
IPADD 0.0.0.0 IP Address of the deskphone. Range is 7 to 15
ASCII characters (less than the default string
length) defining one IP Address in dotted-decimal
format.
L2Q 0 Requests 802.1Q tagging mode (auto/on/off).
Values are:
0 = Auto
1 = On
2 = Off
L2QAUD 6 Layer 2 audio priority value. Range from 0 to 7.
L2QSIG 6 Layer 2 signaling priority value. Range from 0 to 7.
Parameter Name Default
Value
Description and Value Range
To Next Page
Loading...
