Administering deskphone options
94 Administering Avaya 9601/9608/9608G/9611G/9621G/9641G IP Deskphones SIP
Comments? infodev@avaya.com
PHY2STAT 1 Secondary Ethernet interface setting. The values
are: 0=Secondary Ethernet interface off or
disabled, 1=auto-negotiate, 2=10Mbps half-duplex,
3=10Mbps full-duplex, 4=100Mbps half-duplex,
5=100Mbps full-duplex.
PHY2TAGS 0 Specifies whether the deskphone removes the tags
from frames that the deskphone forwards to the
secondary Ethernet interface. You can assign the
following values to this parameter:
0: To remove the tags.
1: To not remove the tags.
For example,
SET PHY2TAGS 1
PHY2VLAN 0 VLAN identifier used by frames received on or
forwarded to the secondary Ethernet interface. Set
this parameter only when VLAN separation is “1”
(enabled). Value is 1-4 ASCII numeric digits from
“0” to “4094.” Null is not a valid value, nor can the
value contain spaces.
PLAY_TONE_UNTIL_RTP 1 Determines when to cut through RTP for an early
media session. Values are:
0 = Cut through RTP as soon as SDP is received.
1 = Cut through RTP only after RTP is received
after received SDP.
Parameter Name Default
Value
Description and Value Range
To Next Page
Loading...
