Avaya B199 - Page 36

Name Description
Webapp debug To enable or disable the debugging function for the web application. It activates
the web application logging available in the System Logs tab. By default,
Webapp Debug is off.
Note:
You can use this function only through the web interface.
Daisy Chain To choose a mode, in which your B199 Conference Phone operates in case of
a daisy chain arrangement. The options are:
• Master. This is the default setting.
• Slave
Note:
You can configure this parameter if you logged in with the administrator
password.
Factory Reset To reset the phone to its factory settings. By resetting the phone to its factory
settings, you remove all the configurations set, imported and installed in course
of the phone use.
Note:
You can do the factory reset only if you log in with the administrator
password and only on the phone.
Time
Enable NTP To enable or disable the Network Time Protocol (NTP). By default, NTP is
enabled.
Note:
You can configure this parameter if you logged in with the administrator
password.
NTP Server To specify the NTP server when NTP is enabled. By default the phone uses the
following NTP server: 0.pool.ntp.org.
Note:
You can configure this parameter if you logged in with the administrator
password.
Table continues…
Settings configuration and management
August 2020 Using Avaya Conference Phone B199 36
Comments on this document? infodev@avaya.com