3. Refer to the screen shot below for the steps to configure Avaya Services Port:
a. Log in to the ACP130 ESXi 6.5 host SSH console using root credentials, using
PuTTY.
The default password is: ACP130_pw
b. Run the following command:
cd /bin
c. Ensure that the file, ACP130srvprt-cfg.sh is present and permissions for root are
executable (make executable if required [“chmod 755” command in scrape below]).
d. Run ./ACP130srvprt-cfg.sh, to configure vSwitch1.
e. Verify vSwitch0 and vSwitch1 are now configured and the services port group is set
to IP address 192.11.13.6/30 on vmk1. Type exit to terminate the session.
The services port is now configured.
Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 48
Comments on this document? infodev@avaya.com
To Next Page
Loading...
