3. Under Controller Properties, set Auto Import Foreign Configuration to Enabled.
4. Click Apply Changes.
5. Scroll down and click OK.
6. Click Back.
Next steps
Proceed to Creating a virtual disk on page 71 for the steps to create a virtual disk by selecting
the RAID level, physical disks, and virtual disk parameters.
Creating a virtual disk
About this task
Use this procedure to create a virtual disk by selecting the RAID level, physical disks, and virtual
disk parameters.
Before you begin
• Delete all existing configurations on the RAID controller.
• Configure the controller properties.
• Ensure that Auto Import Foreign Configuration is set to Enabled.
Dell USB R640 RAID Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 71
Comments on this document? infodev@avaya.com
To Next Page
Loading...
