Avaya Converged Platform 130 Series - Services Port Configuration

5. Confirm the settings with the following command:
esxcli system snmp get
Services Port Configuration
Purpose
This section provides instructions for configuring the Avaya Converged Platform 130 Series
services port using the ACP130srvprt-cfg.sh script. The services port will provide Avaya
support and technicians with access to the server for maintenance and troubleshooting activities.
Configuring Avaya Converged Platform 130 Services Port
About this task
Use this procedure to configure Avaya Converged Platform 130 Services Port.
Important:
For any Avaya Converged Platform 130 server shipped before March 15, 2019, the services
port was not configured at the factory. Avaya Converged Platform 130 server recovery or
software remastering will require the ACP130srvprt-cfg.sh script to be copied to the ESXi
shell and the script to be run. On a recovery, this script should be run prior to deploying any
OVAs. Refer to the Before you begin section below before running the services port script, to
validate the configuration before proceeding. The ACP130srvprt-cfg.sh script can be
obtained from http://plds.avaya.com using the PLDS download ID ACP0000002.
Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 46
Comments on this document? infodev@avaya.com