If there is a peer certificate and a Master-Key listed, TLS v1.0 is still enabled.
2. To validate TLS v1.1 disablement, do the following:
a. Open an SSH session into the ESXi host.
b. Enable Bash shell by typing shell in the command line.
c. Type the following command to validate if TLS v1.1 has been disabled:
openssl s_client -connect localhost:443 -tls1_1
Command results should display that there is no certificate and no Master-Key
assigned. See example below:
Dell R640 XL ESXi Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 57
Comments on this document? infodev@avaya.com
To Next Page
Loading...
