Important:
This procedure will delete all previously written data on the HDDs. Use this procedure only if
the previously configured RAID array/virtual drive needs to be deleted and re-created.
Before you begin
• Connect your VGA monitor, USB keyboard, and USB mouse to the server.
• Power up the server.
Procedure
1. When the hardware boot screen appears, select <F2>System Setup.
Blue highlight indicates that you selected the System Setup Menu.
2. Clear all existing arrays by doing the following:
a. Click Device Settings > Integrated RAID Controller 1: Dell <PERC H730P Mini>
Configuration Utility.
Dell USB R640 RAID Configuration
October 2019 Installing the Avaya Converged Platform 130 Series 67
Comments on this document? infodev@avaya.com
To Next Page
Loading...
