6
Rear View Features of Avid NEXIS | E2, Avid NEXIS | E2 SSD, Avid NEXIS | SDA
Avid NEXIS | E4 Front View
The front of the Engine has a removable bezel (not shown). Removing the bezel allows access to the drive slots.
The Avid NEXIS | E4 Engine supports two Media Packs (10 drives each) for media storage and two system
drives. As shipped from Avid, the system drives occupy the first two slots in the Engine (0 and 1). Drive slot
numbering is shown below.
The drives in the Avid NEXIS | E4 Engine are numbered from top left (0) to bottom right (23), as shown.
Avid NEXIS | E4 Rear View
The rear of the Avid NEXIS | E4 provides access to the Controllers and the PCMs. If you use a redundant
Controller, it must be installed in the third slot from the top, as shown.
Component Notes
PCM (Power/Cooling
Module)
764W power supply and cooling fan modules.
The left power supply is numbered 0, the right is numbered 1, in event and error messages.
Storage Controller Avid NEXIS | E2 SSD uses only one Controller, upside down in slot 1 (bottom slot).
Avid NEXIS | E2 and Avid NEXIS | SDA can use one or two (redundant) Controllers. The
second Controller is upside down in slot 1 (bottom slot).
To Next Page
Loading...
Need help?
General
