40
Installing the Software and Setting up the Avid NEXIS System
Through the setup wizard, you can configure multiple Engines, both with and without a Avid NEXIS | SDA,
identified by a single Storage System Name. You can also configure a redundant Controller in specific Avid
NEXIS Engines or Avid NEXIS | SDA, effective with Avid NEXIS v6.1 and higher.
See “Supported Configurations” on page 2 for configurations that can share the same name space and see “Types
of Controllers” on page 12 for systems that support redundant controllers.
g
If you are deploying a Avid NEXIS | SDA, configure it first, then configure the Engines.
This procedure covers all cases and indicates which of these steps applies to configuring multiple Engines.
c
Each Avid NEXIS Engine and the Avid NEXIS | SDA, if applicable, must be connected to a switch for the
software installation and configuration to work. If you have not yet connected the Avid NEXIS to a switch,
see the Avid Network and Switch Guide.
To configure the system:
1. Open a browser and go to https://169.254.10.10:5015
n
You might see a warning about the site’s security certificate. Double-check the IP address, and if it is correct, click
Continue to this website
.
2. At the login screen, enter the default password,
se-admin
The wizard starts on the Install page.
To Next Page
Loading...
Need help?
General
