Chapter 3: Pro Tools | SYNC HD Hardware 17
Chapter 3: Pro Tools | SYNC HD Hardware
Pro Tools | SYNC HD Front Panel
Controls and Displays
All SYNC HD local controls are on the front
panel. For information on back panel connectors
and setup, see Chapter 2, “Installation and Config-
uration.”
Power Switch
When the SYNC HD power switch is pressed in,
power is on; when the switch is out, power is off.
The LED ring around the power switch is orange
while the SYNC HD is powering up, or while
firmware is being updated. The LED ring is green
when the SYNC HD is ready for use.
Clock Reference Switch and LEDs
This switch selects the SYNC HD clock reference,
as indicated by the Clock Reference LEDs. Avail-
able clock reference inputs include:
•VideoRef:
•Green = SD
• Yellow = HD
•VideoIn
• LTC (Linear Timecode)
• Digital Word/AES:
• Green = Word
• Yellow = AES/EBU
•Pilot
• Bi-phase/Tach
• Internal/VSO
• Loop Sync
Figure 1. Pro Tools | SYNC HD front panel
Frame Rate Switch
Positional Reference
Switch
Generator/Parameter
Controls
Clock Reference
Switch
Power
Clock Reference
LEDs
Loop
Master
Sample Rate
LEDs
Timecode Display
Positional
Reference LEDs
Status LEDs
Frame Rate
LEDs
Drop Frame
LED
To Next Page
Loading...