41
A360 P
e r s o n A l Mi x e r Us e r GU i d e
Press the Recall button followed by a channel button to recall a mix.
P
No t e : Mixes cannot be saved or recalled if a channel is in Solo mode, as indicated by the flashing
green Solo LED.
Clear a Mix
The current mix can be cleared and reset by holding the re C A l l button and then pressing the mu t e
button, returning all channel level settings to their default values. Resetting a mix does not erase the mix
parameters stored in memory for a standard Mix Preset or Instant Mix Recall location. To overwrite a mix
after performing a reset, use the Save button procedures described previously. See page 38.
This command resets the following:
Channel volumes are set to zero •
All channels are • unmuted
Pan for all channels is set to center •
Spread for all stereo channels is set to full •
Channel Tone settings are set to center (flat) •
Reverb levels for all channels are set to zero •
Groups are cleared •
The Dual Profile Channel’s mix values are reset for Profiles A and B •
Profile A is selected •
Channel Button 1 is selected •
Ambience is reset to its default level •
Channel mapping assignments, the Mode switch position, and all saved Mix Presets are unaffected.
To Next Page
