52
A360 P
e r s o n A l Mi x e r Us e r GU i d e
Loading a Mixer Configuration
A USB memory stick can hold up to 16 different mixer configurations, numbered 1 through 16, that
have been created using the A360 Channel Manager software or saved directly from an A360 Personal
Mixer. Custom channel maps and Mix Presets travel together as a single unit—the configuration file; the
underlying components of a configuration cannot be individually loaded.
Mixer configurations make it easy to copy Mix Presets from one A360 to another. They are also used to
assign a unique set of network slots for each performer and then quickly load those custom channel maps
into each A360 Personal Mixer in a personal mixing system.
To load one of the mixer configurations from a USB memory stick into an A360:
Insert a USB memory device into the 1. USB port on the A360.
Place the A360 in 2. Pr o G r A m mode using the rear-panel switch. All Reverb, Tone, Volume,
Pan, and channel button LEDs go out; all mixing functions are disabled.
The 3. SA V e and re C A l l buttons start blinking.
Press the 4. r
e C A l l button; it lights solid and all mix channel buttons start blinking.
Select the channel button (1-16) that corresponds to the mixer configuration you wish to 5.
load. That channel button’s LED lights solid, all other channel button LEDs stop blinking.
Set the rear-panel 6. mode switch in the desired position: P
r o 16, De f A u l t , or Cu S t o m . You
must choose the Cu S t o m position to use channel mapping created with A360 Channel
Manager.
Remove the USB memory stick. 7.
P
No t e : When a configuration is loaded into the A360, any previously loaded channel map is replaced;
Mix Presets stored with the configuration are also loaded and will replace any user-created
mixes saved in the A360. Always back up important data in a Personal Mixer before loading
configurations.
Error Warnings While Loading and Saving
While recalling a configuration, if you select a mix channel button that does not correspond to a valid
mixer configuration file stored on the USB device, the re C A l l button will blink as an error warning. The
A360 will then revert to blinking the SA V e and re C A l l buttons as described above. As in the steps above,
press the re C A l l button and select a different channel button.
If you place the mode switch into the P
r o G r A m position when no USB device is connected, or remove the
USB device prior to performing a save or load operation, the A-Net LED will blink as an error indication.
Simply reconnect the USB device to continue.
To Next Page
Loading...
