Avision FF-1105B - Troubleshooting; Scan to SD;Flash Mode Issues

User’s Manual
9-1
9. Troubleshooting
If you have problems with the operation of the product, please
check the following troubleshooting hints.
9.1 Questions in “Scan to SD/Flash” mode
Question:
There are strange lines on the
scanned image, or the image is not
clear.
Answer:
Check the following:
•
Are there scratches on the original,
or is the original clean? Remove
any stains or dust from the original
before scanning.
• Has the scanner been used for a
long period of time without
cleaning and calibration? Follow
the instructions for "Cleaning the
Scanner" and "Calibrating the
Scanner", and then try again.
Question:
The original gets stuck halfway in
the feeding slot.
Answer:
Press the Function button. The
scanner will back out the original so
you can remove the jammed original
from the output slot.