By Length+Position: When a multi-feed is detected for the
first time, the scanner memorizes the length and position of
the paper attached to the document. When you perform next
scanning, this pattern of multi-feed will be bypassed.
To use the intelligent mode,
1. Choose your desired multi-feed detecting method to
bypass by.
2. When multi-feed occurs during scanning, a multi-feed
message appears.
3. Press the Scan button on the scanner. The LED indicator
first turns to red color and then stays in green color.
4. Click OK to close the multi-feed message.
5. Open your TWAIN data source in your scanning
application. The same multi-feed condition will not be
recognized as multi-feed.
Note:
1. You can clear the previous multi-feed conditions by
clicking the Reset button.
2. The scanner can memorize to bypass up to 25 multi-feed
conditions.
3. If you uninstall your scanner driver, the previous multi-
feed conditions which have been set to memorize and skip
will still be valid.
To Next Page
Loading...
