10
Additional settings
This section covers all the important configurations that an installer needs to do to get the product up and
running after the hardware installation has been completed.
Change the root password
1. Log in to the device interface and go to System > Users.
2. For the root user, click > Update user.
3. Enter a new password and save.
Set up direct SIP (P2P)
VoIP (Voice over IP) is a group of technologies that enables voice and multimedia communication over IP
networks. For more information, see .
In this device VoIP is enabled through the SIP protocol. For more information about SIP, see
There are two types of setups for SIP. Direct or peer-to-peer (P2P) is one of them. Use peer-to-peer when the
communication is between a few user agents within the same IP network and there is no need for extra features
that a PBX-server could provide. For information on how to set it up, see .
1. Go to Communication > SIP > Settings and select Enable SIP.
2. To allow the device to receive incoming calls, select Allow incoming calls.
NOTICE
When you allow incoming calls, the device accepts calls from any device connected to the network. If the
device is accessible from a public network or the internet, we recommend you not to allow incoming calls.
3. Click Call handling.
4. In Calling timeout, set the number of seconds that a call will last before it ends if there is no answer.
5. If you have allowed incoming calls, set the number of seconds before timeout for incoming calls in
Incoming call timeout.
6. Click Ports.
7. Enter the SIP port number and TLS port number.
Note
• SIP port – for SIP sessions. Signalling traffic through this port is non-encrypted. The default port number
is 5060.
• TLS port – for SIPS and TLS secured SIP sessions. Signalling traffic through this port is encrypted with
Transport Layer Security (TLS). The default port number is 5061.
• RTP start port – the port used for the first RTP media stream in a SIP call. The default start port is 4000.
Some firewalls can block RTP traffic on certain port numbers. The port number must be between 1024
and 65535.
8. Click NAT traversal.
9. Select the protocols you want to enable for NAT traversal.
Note
Use NAT traversal when the device is connected to the network from behind a NAT router or a firewall. For
more information see .
10. Click Save.
AXIS A8207-VE Mk II Network Video Door Station
To Next Page
Loading...
