13
1. Go to Reader > Connection.
2. Select Wiegand as protocol type.
3. Turn on Beeper.
4. Under Input for beeper, select I3.
5. In Input used for LED control, select 1.
6. Under Input for LED1, select I1.
7. Select what colors to use for each state.
8. Under Keypress format, select FourBit.
9. Click Save.
10. Go to Reader > Chip types and activate the chip types you want to use.
Note
You can keep the default set of chip types but we recommend that you modify the list according to your
specific needs.
11. Click Add data set to specify the data sets for the different chip types.
12. Click Save.
Use protected data on cards to increase security
To increase security in your access control system, you can choose to use secure card data stored on some types
of cards. The data is protected by a secret key. To read the card data, you need to store the secret key and other
information about the card on the device.
1. Go to Reader > Chip types.
2. Under Data sets, select the chip type you want to edit and click Add data set.
3. Enter information about the card data. What information to enter depends on the card type and how
the cards were enrolled.
4. If you use the OSDP or Wiegand protocols, select Use as UID to send the secure data as the UID/CSN
instead of the normal card UID/CSN.
5. To only allow cards that comply with the specified card data to be sent to the access controller, select
Required data. Cards that don't comply are silently ignored by the reader.
6. Click Save.
Use DTMF to unlock the door for a visitor
When a visitor makes a call from the door station, the person who answers can use the Dual-Tone Multi-
Frequency signaling (DTMF) of his SIP device to unlock the door. The door controller unlocks and locks the door.
This example explains how to:
• define the DTMF signal in the door station
• set up the door station to:
– request the door controller to unlock the door, or
– unlock the door using the internal relay.
You make all settings in the door station’s webpage.
Before you start
• Allow SIP calls from the device and create a SIP account. See and .
Define the DTMF signal in the door station
1. Go to Communication > SIP > DTMF.
2. Click + Add sequence.
AXIS A8207-VE Mk II Network Video Door Station
To Next Page
Loading...
