11
Set up SIP through a server (PBX)
VoIP (Voice over IP) is a group of technologies that enables voice and multimedia communication over IP
networks. For more information, see .
In this device, VoIP is enabled through the SIP protocol. For more information about SIP, see
There are two types of setups for SIP. A PBX server is one of them. Use a PBX server when the communication
should be between an infinite number of user agents within and outside the IP network. Additional features
could be added to the setup depending on the PBX provider. For more information, see .
1. Request the following information from your PBX provider:
– User ID
– Domain
– Password
– Authentication ID
– Caller ID
– Registrar
– RTP start port
2. Go to Communication > SIP > Accounts and click + Add account.
3. Enter a Name for the account.
4. Select Registered.
5. Select a transport mode.
6. Add the account information from the PBX provider.
7. Click Save.
8. Set up the SIP settings in the same way as for peer-to-peer, see . Use the RTP start port from the PBX
provider.
Create a contact
This example explains how to create a new contact in the contact list. Before you start, enable SIP in
Communication > SIP.
To create a new contact:
1. Go to Communication > Contact list.
2. Click + Add contact.
3. Enter the first and last name of the contact.
4. Enter the contact’s SIP address.
Note
For information about SIP addresses, see .
5. Select the SIP account to call from.
Note
Availability options are defined in System > Events > Schedules.
6. Choose the contact’s Availability. If there’s a call when the contact isn’t available, the call gets canceled
unless a there’s a fallback contact.
Note
A fallback is a contact, to whom the call gets forwarded if the original contact doesn’t reply or isn’t available.
7. In Fallback, select None.
AXIS A8207-VE Mk II Network Video Door Station
To Next Page
Loading...
