AYRO VANISH - Battery Charging Warnings

BATTERY PACK AND CHARGING
~ 53 ~
Always make sure power charging cable is installed properly and securely
during vehicle baery charging.
NEVER
connect a 12-volt accessory directly to the tracon baeries. Yo ur
authorized AYRO Dealer can properly make any needed connecons.
NEVER connect jumper cables to any of the baeries on your Vanish.
Always wear safety glasses or approved eye protecon when servicing the
vehicle. Wear a full-face shield and gloves when working around baeries
and electrical connectors.
Always keep 12V accessory baery terminals and connecons clean and
free of corrosion.
Do not drive through water above the floor of the vehicle. Do not use
high-pressure water to wash the baery compartment.
Failure to maintain baeries in accordance with the Operator’s Manual
can result in baery damage, vehicle malfuncon, fire, and/or severe
injury or death.
Max towing speed 10 mph (16 km/h) – baery or drivetrain damage will
occur if towing faster than 10 mph (16 km/h).
11.2 Baery Charging Warnings
Do not charge baeries in a non-venlated enclosed area or near
flammable materials.
ALWAYS Connect baery charger to an electrical receptacle rated at 20A
minimum.
Do not aempt to charge frozen, leaking, or damaged baeries.
Do not charge in a non-venlated storage area or vehicle weather cover.
HIGH VOLTAGE CABLES and terminals are contained within the baery
box compartment. Improper contact with baery terminals can result in
electrical shorts.
ELECTRICAL SHORTS can result in severe burns, shock, or death.