AYRO VANISH - Wheel Installation

MAINTENANCE
~ 73 ~
A falling vehicle can cause serious injury or death.
NEVER place any part of your body under an elevated vehicle. If you need
access to the boom of the vehicle, use automove jack stands to
support the vehicle on a firm, level surface. Your authorized AYRO Dealer
can assist.
Posion the vehicle on a dry, firm, level surface.
Set the park brake.
Turn the key switch to « OFF » and remove the key.
Chock both the front and rear of the re that is located diagonally opposite the jacking
posion. For example, if the right front re is being changed, chock the le rear wheel.
Use a small floor-style jack or hydraulic jack. Jack the vehicle only from the recommended Jack
Points. FRONT JACK POINTS are on the subframe rail, just behind the front wheels. REAR
JACK POINTS are along the rear axle, but not under the gearbox.
Jacking at any locaon other than the recommended jacking points may
cause significant damage to the vehicle frame and body. Only use jacks
cerfied to support the weight of the vehicle.
Remove the wheel nuts.
Remove the wheel.
14.13 Wheel Installaon
Improperly installed wheels can adversely affect re wear and vehicle
handling, which can result in serious injury or death. Always ensure that all
wheel/lug nuts are torqued to specificaon (83 lbf- or 113 N-m).
Place the wheel in the correct posion on the wheel hub. Be sure the valve stem is toward the
outside and rotaon arrows on the re point toward forward rotaon.
Aach the wheel nuts and finger ghten.
Carefully lower the vehicle to the ground.
Torque the wheel nuts to specificaon (83 lbf- or 113 N-m). See page 71.