User Manual
PPPOE (DSL)
When using Point To Point Protocol over Ethernet (PPPOE), your router should be
connected to a modem that is in bridge mode. This is usually used for DSL Internet.
Username and Password The account and password that your ISP assigned to you. For security, this field
appears blank. If you don't want to change the password, leave it empty.
Service Name (Optional) Type the service name if your ISP requires it. Otherwise, leave it blank.
Idle Time You may enter the number of time when Reconnect Mode is Connect on Demand.
MTU Size Change the MTU size that your ISP provided. The default value is 1400 and range is 1360 to 1492
bytes.
Enable uPNP You can select it according to your request.
Enable IPsec/PPTP/L2TP pass through on VPN connection Check the protocol used for your VPN.
Page 28 of 57
To Next Page
Loading...
Need help?
General
