INTRODUCTION
HOW TO USE THIS MANUAL (continued)
1 - 4 I-E96-207A
®
HOW TO USE THIS MANUAL
(continued)
4. Read Appendix A for steps to configure the termination
units.
5. Refer to Section 6 for steps to follow to correct error
conditions.
6. Refer to Section 2 for more COM theory.
7. Refer to Section 9 for steps to order parts and services.
RELATED EQUIPMENT
Hardware Nomenclature
Analog Control Station IISAC01
Control I/O Termination Unit
TCS Cables
Controller Module to TCS
SAC to TCS
SAC to TCS (daisy chain)
NTCS02
NKTU01
NKCS01
NKCS02, NKDS04
Control I/O Termination Module
ICS Cables
Controller Module to ICS
SAC to ICS
NICS01
NKTM01, NKTU02
NKTD02
Module Mounting Unit IEMMU01
IEMMU02
IEMMU04
Station Termination Module
IDS Cables
ICS to IDS
SAC to IDS (single station)
SAC to IDS (two stations)
SAC to IDS (daisy chain)
NIDS01
6634408 (ribbon cable)
NKTD01
NKDS01
NKDS02, NKDS04
To Next Page
Loading...
