What to do if Bailey Control Unit COM has a solid red LED in EXECUTE mode?
If the Bailey Control Unit COM shows a solid red LED while in EXECUTE mode, this indicates a fatal error that immediately impacts execution. The suggested solution is to replace the COM with a known good one, after removing the faulty one. Be sure to follow the configuration instructions provided in Appendix A for the replacement.
General| Category | Control Unit |
|---|---|
| Series | INFI 90 |
| Compatibility | INFI 90 System |
| Mounting | Rack Mount |
| Power Supply | 24 V DC |
Safety info for environment, shock hazards, and special handling.
Warnings on output behavior, MOS device handling, and electrical hazards.
Details power requirements, memory, execution rate, and operating specs like outputs, linearity.
Details analog input/output capabilities, signal types, and circuit configurations.
Explains analog input calibration and details analog output operation.
Covers digital I/O capabilities and input conditioning for the COM module.
Details the maximum I/O capability and field wiring termination.
Covers hardware and software security functions to minimize errors.
Explains how module outputs default to known states during failures.
Explains installation intro, special handling for MOS devices, and unpacking/inspection.
Covers safety info, and steps for setting dipswitches and configuring termination units.
Details the function of switches S1, S2, S3, and S4 for module configuration.
Details using switch S4 for addressing and jumpers for digital input configuration.
To Next Page
