Balboa tp740 - Page 36

36
CLIM8ZONE
TM
Heat Pump
BALBOA | Your Single Source Solution Document No. 42418 Rev. B1 - 04/16/24
Language: English
TP740 User Guide
CLIM8ZONE
TM
MODES
3 speed modes:
1 - Auto Smart (Default)
• For heating or cooling.
• Uses artificial intelligence.
• Variable heating/cooling capacity.
• The Clim8zone
TM
computer automatically adjusts
the compressor frequency up or down using an
algorithm that is based on ambient air
temperature and water temperature.
• This algorithm balances a best case in most
conditions for efficiency and noise vs heating/
cooling output of the Clim8zone
TM
unit.
2 - Manual High
• For heating or cooling.
• Highest heating capacity.
• Fastest water heating/cooling.
• Low COP (i.e. Low Energy Efficiency).
• High compressor frequency – Fixed, i.e. does not
adjust based on environmental conditions.
3 - Manual Low
• For Heating or Cooling.
• Lowest Heating/Cooling Capacity.
• Slowest Water Heating.
• High COP (i.e. High Energy Efficiency).
• Low Compressor Frequency – Fixed, i.e. does not
adjust based on environmental conditions.
4 Clim8zone
TM
modes:
1 - Heat and Cool
This mode heats and cools the spa
water with the Clim8zone
TM
unit enabled.
2 - Heat Only
This mode only heats the spa water.
All cooling with the Clim8zone
TM
unit is disabled.
3 - Cool Only
This mode only cools the spa water.
All heating on the spa is disabled.
4 - Disabled
The Clim8zone
TM
unit is disabled.
4 eHeater modes:
Modes 1 - 3 are manually selectable.
1 - Continuous
The electric heater (eHeater) is continuously
enabled.
2 - Auto
Auto mode activates the electric heater if the
water temperature at the start of heating is at
least 10 °F below the set temperature.
3 - Disabled
The electric heater is continuously disabled.
4 - Enabled
The electric heater is continuously enabled.
This setting is selected automatically when
Clim8zone
TM
mode is set to “Disabled.”