www.baldormotion.com
Configuration 6-25MN1942
6.5.2 Parameters tool
The Parameters tool can be used to view or change most of the drive’s parameters.
1. Click the Parameters icon in the Toolbox on the
left of the screen.
The main area of the Mint WorkBench window
displays the Parameters editor screen.
Items listed with a grey
icon are Read Only
so cannot be changed.
Items listed with a green
icon are currently set to their Factory Default value.
Items listed with a yellow
icon have been altered from their factory default value, either
during the commissioning process or by the user .
2. In the parameters tree, scroll to the required item.
Click on the small + sign beside the item’s name.
The list will expand to show all items in the
category.
Click on the item you wish to edit.
3. The adjacent table will list the chosen item.
Click in the Active Table cell and enter a value.
This immediately sets the parameter, which will
remain in the MicroFlex e100 until another value
is defined. The icon to the left of the item will
become yellow to indicate that the value has
been changed.
Many of the MicroFlex e100’s parameters are set automatically by the Commissioning
Wizard, or when tests are performed in the fine- tuning window .
To Next Page
Loading...
