www.baldormotion.com
Configuration 6-27MN1942
6.5.4 Other tools and windows
Remember, for help on each tool just press F1 to display the help file, then navigate to the Mint
W orkBench book. Inside this is the Toolbox book.
H Edit & Debug Tool
This tool provides a work area including
the Command window and Output
window . The Command window can be
used to send immediate Mint
commands to the MicroFlex e100. If
you tried the test moves in section 6.4.7
or 6.4.8, then you have already used
Edit & Debug mode. Press Ctrl+N to
open a new Mint program editing
window .
H Scope Tool
Displays the capture screen. This screen is also shown when the Fine-tuning tool is
selected.
H Digital I/O
Allows you to configure the active states
and special assignments for all the digital
inputs and outputs .
To Next Page
Loading...
